P| 4
ARCHED GARDEN ARBOR
www.ForeverRedwood.com
NOTE:
In order to know where the posts need to be placed, check the numbers on them. If the post is not marked, then place the
arched roof timbers on the ground to locate the markings for each post position and clearly set your bearings. (“Don´t attach yet,
only place them on the ground to begin with”).
Step 1:
Install the anchor bases
(7)
with ½´´ X 4´´ anchor bolts
(A)
or lag bolts. Please see the “How to anchor your pergola
document” for all details. Set your post
(1)
in the saddle of the anchor bases. Drill a ø ¼´´ hole in the post prior to anchoring to
facilitate the ratcheting of the hardware. After that, use a 5/16´´ X 3´´ lag bolts
(B)
to attach each post to its respective anchor
base
.
Step 2:
Attach the supports
(2)
to the posts with 5/16” x 3 ½” bolts
(C)
washers & nuts. Tap the bolt all the way into the wood
to set it. Then add a washer and nut and lightly tighten. Each part has a series of numbers that indicate where to attach the part
with the corresponding number.
1
2
2
5/16´´ X 3 ½ ´´ Bolts
5/16´´ X 3´´
Lag Bolts
1
1
1
7
