12
4.0. OPERATION GUIDE
█ 4.3. REMOTE CONTROL OPERATION
Inserting Batteries in the Remote Control
1.
Press and slide down the battery compartment
cover (located on the back of the remote) to
remove it.
2.
Insert two new R03 “AAA” 1.5 V batteries into
the battery compar tment. Be sure to match the
polarities correctly.
3.
Replace the cover.
Caution :
▪ Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
▪ If the remote control is not be used for a certain length of time, remove the batteries (batteries may
explode or leak).
▪ If the remote control unit is replaced or discarded, the batteries must be removed and disposed of in
accordance with current legislation as they are harmful to the environment.
Operation Recommendations
▪ Point the remote control to the air conditioner
and press the desired keys. The remote control
must be no more than 5 m (16 ft) away from the
appliance (without obstacles between the remote
control and the appliance).
▪ Avoid pressing two buttons simultaneously as this
may cause malfunctions.
▪ Avoid using the remote in areas with extreme
temperature fluctuations.
▪ If the remote is not be used for extended periods of time, remove the battery.
Caution : The remote control must be handled with care. Do not drop or expose it to direct sources
of heat, sunlight or water.
█ 4.4. OTHER FUNCTIONS
COMPRESSOR PROTECTION
To increase the service life of the compressor and its components, it has a
3-minute auto restart delay
after it has been turned off. This means if you turn off the appliance and then on again immediately after,
or are rapidly cycling through the operation modes (some modes, like
Ventilation
, do not make use of the
compressor and will turn it off), the compressor will delay its startup by 3 minutes.
FIG. 14 – Replacing the batteries
FIG. 15 – Using the remote
MAXIMUM 5 M (16 FT)