5mm
Allow a 5mm gap at the top
when fitting the door.
PRE-DRILL
WITH 2MM BIT
FOR ALL STEPS
BELOW.
PRE-DRILL
WITH 2MM BIT
FOR ALL STEPS
BELOW.
60
MM
SCREWS
PRE-DRILL
WITH 2MM BIT
FOR ALL STEPS
BELOW.
25
MM
SCREWS
8
6c
Secure the Rim Lock to the Lock Block with
its supplied fixings.
Ensure to hook the Rim
Lock over the edge of the Lock Block. Thread
the spindle through to attach the Handle.
Attach the Door Handle and Escutcheon
to
the external face of the ‘opening’ Door using
their supplied fixings.
Position and secure the Rim Lock Receiver to
the Slamming Strip.
Test the key to ensure the
lock works accordingly.
6b
DOOR ASSEMBLY
Place the Doors into the opening, ensuring
they’re level.
Make sure the hinges are up
against T&G boards and fix into place.
Fix the Lock Block
flush to the corner of the
framework on the back of the ‘opening’ Door
(opposite to the door with the Slamming Strip
attached).
Use a 16mm drill bit for the Door Handle hole.
Use the Escutcheon as a guide with 5-8mm
drill bits and drill 3 x holes to provide the hole
for the key.
LOCK BLOCK
TOP TIP:
Mark out with pencil, use the rim lock
as a guide to drill the holes in the correct positions.
DOOR LOCK
INSIDE
INSIDE
INSIDE
OUTSIDE
OUTSIDE
INSIDE
6d
Fix a Barrel Bolt
to the top of the Slamming
Strip with its supplied fixings as shown below.
Fix a Barrel Bolt
to the bottom of the
Slamming Strip with its supplied fixings as
shown below.
Attach a turn button
at the top and bottom of
the ‘closed’ door.
DOOR FIXINGS
INSIDE
INSIDE
