7
│
Installing the Forest Shuttle S / L / M Receiver
Programming Master
–
Slave function to the
FOREST SHUTTLE® M Receiver
The Forest Shuttle® M Receiver can be programmed as MASTER and SLAVE motor. Two motors are needed, connected together
by a cable from Port 1 to Port 1. Configuration can be done by means of pressing the configuration button on the Shuttle® motors:
Situation 1 (normal Shuttle® M Receiver 5232000003):
LED 1 to 4
Two Shuttle® motors on one track (direction of rotation is the same).
Installation steps:
-
install the track, motors and power plug
-
connect motor A, port 1 to motor B, port 1 by means of a 8 wire flat cable, UTP or FTP (straight) cable.
-
program the MASTER motor: Press the configuration button 17 times shortly, LEDS 1 to 4 will move with every press.
After 17 presses, once more press the button and hold for 4 seconds. LED 1 will blink three times and go off.
-
program the SLAVE motor: Press the configuration button 18 times shortly, LEDS 1 to 4 will move with every press. After
18 presses, once more press the button and hold for 4 seconds. LED 2 will blink three times and go off.
-
Now the SLAVE motor will follow the movement of the MASTER motor. Only the MASTER motor can be controlled.
-
End limits can be set now and remotes can be programmed.
Situation 2 (FSS Shuttle® M Receiver 7131000000):
Two Shuttle® motors drive a Forest Skylight System FSS (direction of rotation is opposite).
Installation steps:
-
install the track, motors and power plug
-
connect motor A, port 1 to motor B, port 1 by means of a 8 wire flat cable, UTP or FTP (straight) cable.
-
program the MASTER motor: Press the configuration button 17 times shortly, LEDS 1 to 4 will move with every press.
After 17 presses, once more press the button and hold for 4 seconds. LED 1 will blink three times and go off.
-
program the SLAVE motor: Press the configuration button 19 times shortly, LEDS 1 to 4 will move with every press. After
19 presses, once more press the button and hold for 4 seconds. LED 3 will blink three times and go off.
-
For both motors: press configuration button 26 times, after that press 4 time for 4 sec. to confirm
-
Now the SLAVE motor will follow the movement of the MASTER motor. Only the MASTER motor can be controlled.
-
End limits can be set now and remotes can be programmed now. It will be hard to move the curtain by hand, because of
the solid coupling inside the FSS motor. This is normal.
