6
FM22P Petrol Log Splitter
Assembly
IMPORTANT:
Parts of the log splitter (such as the ram assembly) are extremely heavy therefore it
is recommended that assembly is undertaken by two persons so that one is able to support parts
while the other secures them in place.
Before commencing assembly, check that you have all the required parts and the correct nuts and
bolts and ensure you have read and understood these assembly instructions. Ensure the assembly
area is clean and free of obstructions.
STEP 2
To make it easier to support the
ram assembly when installing
it, the main beam should be
rotated from the vertical position
in which it was packed, to the
horizontal position. Remove
the “R Clip” from the end of
the “Lock Pin” then remove the
lock pin. Rotate the beam to the
horizontal then replace the Lock
Pin and R Clip.
R Clip
Lock
Pin
Rear
Support
Leg
STEP 1
Secure the handle (10) to the beam using two
M8x20 bolts (11), spring washers (12) and flat
washers (13) at the top of the plate and two
M8x40 bolts (20) with flat washers (13) at the
bottom.
Note that the flat washer should be against
the plate of the handle and the spring washer
between it and the head of the bolt.
Lower the rear support leg and ensure it is
secured with the lock pins.
