ISSUE 0414
5
W
W
F
Fix both of the 800mm strips (W) to the inside of door (F) so they are flush with the top and
bottom of the door and overhang the side by 20mm. Fix each strip in place using 2 x (3.5 x
30mm) screws.
Fix a shoot bolt to the top and bottom of the door. Fix the receiver to the framework between
the two strips as illustrated. Use the 20mm black screws provided.
Still from inside the building line the lock up with the key hole in the door and fix using the 4 x
32mm black screws.
6
8
Forest Garden Ltd. Unit 288 Hartlebury Trading Estate, Hartlebury, Worcestershire, DY10 4JB
380mm
G
L
O
J
Place the roof sheet (J) on to a 2070mm batten (O) so that it sits on to the wider face and is
flush with the sides. Fix using 6 x (3.5 x 30mm) screws spaced evenly.
fix one of the 150mm blocks (L) so this is flush with the roof sheet but is 380mm apart from
the batten. Fix using 2 x (3.5 x 30mm screws).
Repeat this for the other roof to make a left and right hand roof section.
From outside of your
building fix a turn
button to the top and
bottom of the left hand
door using 2 x (4.0 x
30mm zinc) screws.
Make sure that the
turn button will reach
across both doors
when in its closed
position.
Place a 1732mm angled post
(M) against the end of the
handrail so that the pitch of the
angle is towards the apex. Fix
this in place using a corner
bracket. Use 2 x 50mm screws
to secure each bracket to the
floor and 2 x (3.5 x 30mm
screws) to secure this to the
post.
Further secure the post to rails
using 2 x 50mm screws.
E
7
S
I
Place the window (I) into the door end so that there is an equal gap each side before placing
an 848mm (S) (
rebated
) batten on either side. The rebate should sit against the window.
Fix each batten in place using 3 x 50mm screws screwing into the door ends framework.
H
M