12
W
H
X
I
E
Y
Place the sheets in to the door so that each sheet sits on the rebated frame. Place each piece of
beading on top of the sheets makings sure that everything is flush. Fix the beading in place
using Panel Pins.
(X) = 4 x Panel Pins W) = 2 x Panel Pins (Y) = 5 x Panel Pins
9
10
Eaves
ATTENTION:
TAKE CARE
WHEN TRIMMING
THE ROOF FELT.
Unroll the felt and place each section so that they overlap at the apex and overhang on the
eaves by approximately 50mm. Fix the felt to the roof using felt nails spaced in 150mm intervals
along the edges and the seam. Make sure that the felt nails are positioned so that they locate
into the batten on the eaves.
Cut and fold the corners securing with a single felt nail.
E
11
Place the barge boards against the ends of the roof so that they meet at the apex and are flush
on all sides. To secure each barge board in place use 3 x 30mm screws.
Secure the finial in place using 2 x 25mm screws for each.
V
A1
From the outside place the remaining beading against the bottom front of the glazing and fix in
place using 3 x panel pins for each.
Repeat
J
