Rear Pivot Delivery Bearing Assembly - Assistant’s
Rear Pivot Delivery Bearing Assembly - Cuspidor
3 of 4
2 of 4
CAUTION: Threads to be sealed must be clean and dry. Shake the product applicator before use.
CAUTION: Threads to be sealed must be clean and dry. Shake the product applicator before use.
NOTE: For cuspidor refer to page 3.
Routing Drain/Suction Line
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
Removing Chair Covers (continued)
8. Using a 5/32” hex key, remove the screws (2)
on the side covers.
9. Remove upper rear cover.
CAUTION: A wire is connected to the memory button. Be sure not to pull cover completely off
before performing the next step.
10. Disconnect the memory button wire connector by pressing the release clip. Remove upper rear cover.
11. Using both hands, spread the plastic cover and pull outward to lift cover over bolts.
Rear Pivot Mount Kit
1. Reconnect chair to mains power.
Position the chair’s base in a
comfortable working position.
Disconnect chair from mains power.
NOTE: Skip rear pivot mount kit
installation if chair is pretubed.
NOTE: Recessed holes must be
facing upward.
2. Attach the rear assistant mount to the
platform below the chair brake with two
shoulder screws. Tighten in place using
a 1/4” hex key.
Rear adapter
main bearings
Arm side
intermediate
bearings
Assistant’s arm
Rear
adapter
CAUTION: Apply one
drop Loctite 243 to
screw threads.
CAUTION: Grease bearings.
1. Install rear adapter main bearings using illustration above.
2. Proceed to routing drain/suction line.
Rear adapter
main bearings
Arm side
intermediate
bearings
Cuspidor arm
Rear
adapter
CAUTION: Apply one
drop Loctite 243 to
screw threads.
CAUTION: Grease bearings.
CAUTION:
Apply
one drop
Loctite 243
to screw
threads.
1. Install rear adapter main bearings using illustration above.
4. Route umbilical down lift frame and
through umbilical guides.
5. Route umbilical between solenoid manifold and hydraulic fluid reservior.
1. Remove plug from upper rear cover.
2. Route umbilical through upper rear cover.
3. Rest upper rear cover on chair platform.
Platform
Wire connector
Release clip
Mounting shoulder screws (2)
Umbilical
guides
Route
umbilical
Route
umbilical
