8
BATTERY
Make sure the control knob is in the “OFF” position. Unscrew the push button cap on the ignitor module located
on the control panel to access the battery compartment. The ignitor module requires one AAA size battery (See
Figure 13).
WARNING:
1. Please observe proper polarity and use the correct battery type when placing or replacing the battery.
Improper installation could result in ignition failure.
2. Please remove the battery if consumed or if product is to be left unused for a long period of time.
LEAK TEST
To prevent fire or explosion hazard when testing for a leak:
1. Always perform the leak test as described below before lighting this appliance or each time the cylinder is
connected for use.
2. Do not smoke or allow other sources of ignition in the area while conducting a leak test.
3. Conduct the leak test outdoors in a well-ventilated area.
4. Do not use matches, lighters or a flame to check for leaks.
5. Do not use this appliance until any and all leaks are corrected. If you are unable to stop a leak, disconnect
the propane supply. Call a gas appliance service shop or your local propane gas supplier.
cylinder-regulator connection (Figure 14)
gas valve-bellows connection (Figure 15)
Figure 13
