Ford TOURNEO CONNECT, Owner'S Manual, Page: 103 / 437

Fig. 70 Second row of seats: Removing the
two-seat bench.
Fig. 71 Second row of seats: Installing the
two-seat bench.
The seats in the second row are divided in-
to a single seat and a two-seat bench. The
seat and the bench seat can be removed
separately to increase the size of the lug-
gage compartment.
Removing the seat
1. Fold the backrest forwards
→
page 98.
2. Fold the seat forwards
→
page 100.
3. Pull the rods
→
Fig. 69
1
in the direc-
tion of the arrow until both locking
marks
→ Fig. 70
2
are in the red area.
The seat is released.
4. Use the carry grips to remove the seat
by lifting it out of the catch
3
.
Fitting the seat
1. Fit seat in the retainers.
2. Press the rods
→
Fig. 71
1
downwards
in the direction of the arrow until both
locking marks
2
are in the green area.
The seat is locked in position.
3. Fold the seat back
→
page 100.
4. Fold back the backrest
→
page 98.
WARNING
Injuries could be caused if the seats are
removed and installed carelessly.
·
The lock indicator shows the seat is se-
curely engaged . The seat is not secure-
ly engaged if at least one of the lock in-
dicators is in the red area. Always check
that both lock indicators are in the
green area when the seat is installed.
Folding the backrest of the third
row of seats forwards and back-
wards
Please refer to , and at the
start of the chapter on page 97.
Fig. 72 Third row of seats: folding the back-
rest forwards.
1 Release lever.
2
Loop.
Folding the backrest forwards
1. Push the head restraint all the way
down → Fig. 72 (arrows).
2. Pull the release lever
1
fully to the rear
to release the backrest.
Rear seats 101
2KF012
720AB