INSTRUMENT PANEL
2
SPOT LAMPS CONTROL*
The spot lamps are on the
forward-facing side of the exterior
mirrors. With the lighting control
switch in the parking lamps
position, press the buttons located
above the lighting control switch to
activate the left-hand or right-hand
side spot lamps. Once switched
on, the spot lamps light the area
in front of and to the side of your
vehicle. Adjust the aim of the spot
lamps by moving the exterior
mirrors' positions.
Note:
The spot lamps turn off
when you reach a speed of 6 mph
(10 km/h).
3
LIGHTING CONTROL
Headlamps off.
Parking lamps on.
Headlamps on.
Autolamps on.
Automatically switches the
exterior lamps on or off
based on available daylight.
Fog lamps on. Press the
control to switch the fog
lamps on or off. You can
switch the fog lamps on
when the lighting control is
in any position except off
and the high beams are
not on.
4
ELECTRIC PARKING BRAKE*
On certain models, the electric
parking brake replaces the
conventional foot brake. The
operating switch is on the
instrument panel, to the left
of the steering column.
To apply the electric parking brake,
make sure the transmission is
locked into park (P), and then
pull the
switch up. The brake
system warning lamp flashes then
lights to confirm that you applied
the brake.
To release the electric parking
brake, switch the ignition on, press
the brake pedal, and then manually
press the
switch down. The
brake system warning lamp then
turns off to confirm the parking
brake is released.
5
ADJUSTING THE PEDALS*
Move the brake and accelerator
pedals using the control. The
vertical control is to the left of
the steering column and on the
instrument panel. The horizontal
control is on the left side of the
steering column.
Press the left arrow
to move the
pedals away from you.
Press the right arrow
to move the
pedals closer to you.
Adjust the pedals only after
stopping your vehicle and placing it
in park (P).
6
INFORMATION DISPLAY
CONTROLS*
Monitor and control important
vehicle information and features
through the information display.
•
Press the up or down arrows
to scroll through and highlight the
options within a menu.
•
Press the right arrow
to enter
into a sub-menu.
•
Press the left arrow
to exit
a menu.
•
Press
OK
to choose and confirm a
setting or message.
You can even customize your views
using MyView.
Refer to the
Information Displays
chapter in your
Owner’s Manual
for
more details.
7
ADAPTIVE CRUISE CONTROL*
Automatically adjust your speed to
maintain a set distance between
your vehicle and the vehicle in front
of you in the same lane. Set the
gap distance between your vehicle
and the vehicle in front of you by
pressing the
and
controls on
the steering wheel.
If your vehicle follows a vehicle
to a complete stop and remains
stopped for less than three seconds,
your vehicle accelerates from a
stationary position to continue to
follow the vehicle.
If the vehicle you are following
comes to a complete stop and
remains stopped for more than
three seconds, press
RES+
or the
accelerator pedal to continue follow
the vehicle.
Note:
Driving aids do not replace
the need to watch when the
vehicle is moving and brake where
necessary. Refer to the Cruise
Control chapter in your Owner’s
Manual for more details.
8
POWER TILT-TELESCOPE
STEERING COLUMN*
Use the control on the side of
the steering column to adjust
the position.
To tilt:
Press the top or bottom of
the control.
To telescope:
Press the front or
rear of the control.
1
POWERSCOPE
®
POWER TELESCOPING,
POWER-FOLDING, POWER
EXTERIOR MIRRORS*
To telescope both mirrors at the
same time, make sure you switch
your vehicle on (with the ignition
in accessory mode or the engine
running) and then:
1. Press and release the power
fold button
.
2. Press the adjustment control to
position the mirrors.
•
Press the left arrow
to
extend the mirrors out. Press
the right arrow
to retract the
mirrors in.
•
Press the up or down arrow
to fold the mirrors
toward the window glass.
Press the up or down arrow
to fold the mirrors out.
Note:
Moving the mirrors 10 or
more times within one minute, or
repeated folding and unfolding
of the mirrors while holding the
control down during full travel,
may disable the system to protect
the motors from overheating. Wait
approximately three minutes with
the vehicle running, and up to
10 minutes with the vehicle off,
for the system to reset and for
function to return to normal.
1
3
5
6
2
8
7
4
-
5
4
-
5
*if equipped
*if equipped
4
