6. The correct compass heading will be displayed when the compass is
calibrated.
Note:
If the RESET button is not pressed, the compass will exit
calibration mode after three minutes of no activity and the original
calibration data will be restored.
Note:
If power is interrupted during the calibration process, the compass
resets to the original calibration data from before the calibration process
started.
HomeLink
姞
mode (if equipped)
Train mode
Note:
Do not train the HomeLink
威
with the vehicle parked in the garage.
To train a HomeLink
威
button to control a specific device:
1. Select the HomeLink
威
button to
train.
2. Press and continuously hold the
button for 20 seconds. CHANNEL X
TRANSMIT will be displayed (X will
be 1, 2, or 3) during this time.
Note:
If more than one button is
pressed, priority will be given to the
lowest numbered channel.
3. After 20 seconds, the display will
read CHANNEL X TRAINING to
indicate training has started.
Continue to hold the button.
Note:
If the channel being trained
has not been previously trained, the
channel will immediately enter the
training mode (no 20 second delay).
4. Point the original garage door
opener/transmitter at the overhead
console. Hold down the original transmitter’s button so the overhead
console can learn the transmitter’s frequency and data stream.
2003 Town Car
(tow)
Owners Guide (post-2002-fmt)
USA English
(fus)
Driver Controls
89
Summary of Contents for 2003 Town Car
Page 272: ...272...