Ford 2002 Bantam, Workshop Manual, Page: 1329 / 1663

417-01-11 Exterior Lighting 417-01-11
DIAGNOSIS AND TESTING ( CONTINUED )
CONDITIONS DETAILS/RESULTS/ACTIONS
4 Turn the multifunction switch to the LOW
BEAM position.
5 Measure the voltage between relay socket –
low beam, connector C6, pin 2, circuit 14S-
LE19 (VT/BU) and ground.
• Is battery voltage indicated?
Yes
GO TO B2
No
GO TO B3
B2: CHECK THE POWER SUPPLY OF RELAY – LOW BEAM
1 Measure the voltage between relay socket –
low beam, connector C6, pin 5, circuit 30-LE20
(RD) and ground.
• Is battery voltage indicated?
Yes
INSTALL a new relay – low beam. TEST the
system for normal operation.
No
REPAIR the power supply of relay – low
beam, by using the wiring diagrams. TEST
the system for normal operation.
B3: CHECK THE MULTIFUNCTION SWITCH FOR PROPER FUNCTION
1 .
2 Check the multifunction switch, according to
Component Testing attached to the wiring
diagrams.
• Is the multifunction switch OK?
Yes
REPAIR the open circuit(s) between
multifunction switch and relay – low beam,
by using the wiring diagrams. TEST the
system for normal operation.
No
INSTALL a new multifunction switch. TEST
the system for normal operation.
E9418 EN 07/2001 2002 Bantam
BACK TO CHAPTER INDEX
FORD BANTAM
CONTINUED
TO MODEL INDEX
PAGES FROM MANUAL