Force Computers PENT/CPCI-721, Installation Manual

Page: 60 / 126

Switch Settings Installation
2 - 20 PENT/CPCI-721
Switch Settings
The PENT/CPCI-721 is configurable via two micro switches. The
switches are located on the base board and on the I/O panel. The tabs
are in white and are displayed in the off position.
Table 9: PENT/CPCI-721 Switch Settings
Name and Default Setting Description
SW0100 1
OFF User flash IDE mode
OFF= User flash is primary IDE slave.
ON= User flash is primary IDE master.
SW0100 2
OFF Keyboard control
OFF= Keyboard enabled
ON= Keyboard disabled
SW0100 3
OFF Reset key control
OFF= Reset key enabled
ON= Reset key disabled
SW0100 4
OFF Abort key control
OFF= Abort key enabled
ON= Abort key disabled
SW0300 1
OFF BIOS flash write protection
OFF= Writing enabled
ON= Writing disabled
SW0300 2
OFF Reserved
SW0300 3
OFF Ethernet connector selection
OFF= Ethernet via front panel connector
ON= Ethernet via CompactPCI connector
SW0300 4
OFF BIOS flash bootblock write protection
OFF= Write-protected
ON= Writing enabled