8
4. Web GUI
Status parameters of USF-111DDA-12G can be displayed on the Web display if the module is installed
in a USF-212AS/USF-105AS frame. SNMP monitoring is also available. Refer to the
USF-212AS/USF-105AS Operation Manual for details on displaying the Web GUI window.
NOTE
USF-111DDA-12G does not support simultaneous Web GUI access from multiple PCs. Use the
SNMP function to simultaneously monitor a USF-111DDA-12G from multiple PCs.
4-1. WEB Display Information
Start the Web GUI and click on a USF-111DDA-12G from slot 1 to 12 of USF-212AS/USF-105AS to
open the window as shown below.
Module Information
Item
Description
Slot
Slot no. of the USF-212AS/USF-105AS in which USF-111DDA-12G is
installed.
S/N
Serial number of the USF-111DDA-12G.
MAC Address
MAC address of the USF-111DDA-12G.
Firmware
Firmware version of the USF-111DDA-12G.
FPGA
FPGA of the USF-111DDA-12G.
IP Address
IP address of the USF-111DDA-12G.
CPU Temperature Temperature of the CPU on the USF-111DDA-12G front card.
Video Input
Displays video input status.
Detected
:
Normal video input.
Not Detected
: No video input, or input level is low.
Input Status Trap
Sets the SNMP trap setting when monitoring USF-111DDA-12G via SNMP
Manager.
Enable
: Sends input status traps.
Disable
: Sends no traps.
Input Signal
(SD/HD/3G/12G)
Displays the bit rate of SDI input:
SD (270Mbit/sec), HD (1.5Gbit/sec),
3G (3.0Gbit/sec), 12G (12.0Gbit/sec)
Not Detected
: No input signal
Mode
Displays the re-clock function mode.
Output 1-11 Mute
If not connecting video output signal via SDI OUT1-11, set
Enable
for
unused ports. (Recommended use)
