FOR-A UFH-70DAC, Operating Manual

Page: 14 / 22

8
4-3. Dipswitch Setting (FUNCTION)
Setting
Pin No. Item
OFF (Up) ON (Down)
Factory
Set
1=OFF, 2=OFF: YP
B
P
R
SW2-1
1=ON, 2=OFF: GBR
OFF
1=OFF, 2=ON: Y/C
SW2-2
Analog output selection 1
1=ON, 2=ON: Composite
OFF
SW2-3 Analog output selection 2 Composite SYNC OFF
SW2-4
― ― ―
SW2-5
Output selection when
signal not present
BLACK NO SIGNAL OFF
SW2-6 Internal test signal OFF ON OFF
SW2-7
― ― ―
SW2-8
― ― ―
Analog output selection 1 ( SW2-1, 2 )
Selects an output signal format for the connectors Y/G/C1, P
B
/B/C2 and P
R
/R/C3 (see
section 4-3-1). Only YP
B
P
R
or GBR can be selected if an HD-SDI signal is input to the unit.
Analog output selection 2 ( SW2-3 )
Selects an output signal format for the SYNC/C4 connector.
Only SYNC can be selected if an HD-SDI signal is input to the unit (see section 4-3-1).
Output selection when signal not present ( SW2-5 )
Selects black video or no video output from ANALOG OUT when input signal is not present.
No signal will be output from HD/SD-SDI OUT (active through) regardless of this setting
when input signal is not present.
Internal test signal ( SW2-6 )
Outputs a test signal (Color Bar or Cross Hatch) from ANALOG OUT if set to ON. However,
the test signal is not output from HD/SD-SDI OUT (active through). Use dipswitch SW6-8 to
select test signal between Color Bar and Cross Hatch (see section 5-1).
The test signal can be output in synced with the input signal if an HD/SD-SDI signal is input to
the unit. Select the test signal format manually by the SW6 switch setting if any signal is not
input to the unit. Note that the unit may not output test signals correctly if manually selected
format does not match with the input signal. If set to Auto Detection and any signal is not input
to the unit, the last used signal format is selected for the test signal (see section 5-1).
Proc Amp controls cannot be performed during test signal output.