Foppapedretti Logik I-Size, Assembly Instructions Manual

Page: 40 / 200

• ENGLISH • • ENGLISH •
40
USING THE CAR SEAT IN THE VEHICLE
REMOVING THE NEWBORN REDUCER
The newborn reducer (21) gives babies the necessary
support for the early months.
When the baby is over 61 cm tall (about 3 months), the
reducer can be removed.
Remove the headrest reducer by pulling the elastic away
from the headrest.
Remove the seat reducer.
Before washing it, remove the internal padding in the
reducer through the opening located on the side.
When the lining is dry, insert the padding back inside the reducer.
REMOVING THE LINING
Unclip the harness buckle.
Remove the headrest reducer fixed with the elastic.
Remove the seat reducer.
Detach the press studs on the headrest to remove the chest straps.
Detach the press studs on the backrest fabric.
Remove the lining, carefully pulling the fabric off from the headrest.
Carefully pull the fabric off from the frame, starting from one side, paying
particular attention while pulling the fabric off from around the harness adjustment
device.
PUTTING THE FABRIC BACK ON
Repeat the disassembly process in reverse order.
Place the seat lining on the car seat and insert the leg separator harness into the slot.
Carefully replace the fabric around the harness adjustment device and then around
the frame.
Carefully put the fabric back on the headrest.
Put the chest straps back into the headrest reducer slot and attach the press studs.
Attach the press studs in the backrest fabric to the lining fabric.
Attach the buckle and check that the harness straps are not twisted.
Make sure that the chest straps are correctly inserted in the chest protectors.