EN
- 3 -
7.-
EQ-SCAN
: in playback mode, it allows selection among the different equalizations available.
In radio mode, it allows the FM radio stations to be tuned automatically. Tuning starts from the
lowest frequency and the stations will be saved in the memory consecutively and automatically.
8.-
/RPT-MEMORY
: in playback mode, a short press of this button begins and pauses playback.
A long press of this button allows the playback mode to be selected among: random playback
(RAN), repeat one track (SIN), repeat folders (FOL), repeat all (ALL).
In radio mode, this button lets you change successively among the stations saved during
automatic tuning.
9.-
: player module on/off button.
8.- Amplifi er LED power indicator.
9.- Aux input, 3.5 mm jack connector.
Note
: this frontal aux input is the same as the one on the rear panel (AUX).
10.- Aux input or USB/SD/MP3 player selector.
11.-
ZONE 1
: control that regulates the output volume of zone 1.
12.-
ZONE 2
: control that regulates the output volume of zone 2.
13.- Amplifi er on/off switch.
REAR PANEL
-
PA AMPLIFIER MA-61RUZ
INPUT 1
INPUT 2
AUX / MP3
TREBLE
BASS
ZONE 1
ZONE 2
VOL
AUX
MP3
VOL -
FM/SD/USB EQ
SCAN
/RPT
MEMORY
VOL +
MA-61RUZ
PA AMPLIFIER
60 W RMS
POWER CONSUMPTION: 83 W
FM
GAIN
PRIORITY 100 V INPUT
PRIORITY
GND
LINE OUT
AUX
INPUT 2
INPUT 1
R
L
R
L
~110-120 V AC. 50/60 Hz FUSE: T1.6AL 250 V
~220-240 V AC. 50/60 Hz FUSE: T800mAL 250 V
115 V
230 V
LINE
PHANTOM
+24 V
MIC
LINE
PHANTOM
+24 V
MIC
CLASS II WIRING
COM
COM
Z1
Z2
COM
4 Ω
70 V
100 V
1
1
6
7
8
9
10
12
11
5
2
3
4
9
10
11
12
13
2
3
4
5
6
7
8
1.-
115 V/230 V
: power supply voltage selector.
2.-
FM
: antenna input for the digital FM tuner.
3.-
GAIN
: 100 V line input signal level control.
4.-
LINE/PHANTOM 24 V/MIC
: input and 24 V phantom power supply sensitivity switches. These switches
have three positions:
LINE
: in this position, line level audio sources can be connected to the inputs: CD players, etc.
PHANTOM 24 V
: in this position, electret condenser microphones that require 24 V phantom power
can be connected to the inputs.
MIC
: in this position, the inputs can be connected to low impedance 30-600 Ω dynamic microphones.
5.- AC power supply.
6.-
GND
: earth screw, to be used if the mains does not have one incorporated.
7.- Loudspeaker output. For connecting loudspeakers in 4 Ω low impedance and in high impedance
100/70 V lines. Connect the loudspeaker line between the COM terminal and the impedance or line in
the required volts (V).
