EN
- 6 -
CONNECTION
- Make the connections with the amplifier and all the installation components switched off and disconnected
from the mains.
- Connect the desired audio equipment or microphones to the corresponding inputs. If you connect a
dynamic microphone to input 1 to 3, move the selector to the MIC position. If you connect a condenser
microphone, move the selector to the PHANTOM 18 V position.
If you connect a line level source to inputs 1 to 3, move the selector to the LINE position.
- If you want, you can connect a line level source to INPUT 4 which is prepared for it.
- If you use the 8 Ω low impedance output, you must connect the speakers in a series/parallel circuit so that
the speaker charge impedance is the same as the amplifier output impedance and the power supplied by
the amplifier does not exceed what is withstood by the speakers.
- If you use 100 or 70 V high impedance line output, you must connect all the speakers in parallel and the sum
of the power of all the speakers must not exceed the power supplied by the amplifier.
- Power the
MA45RU
amplifier using the AC mains supply or the 24 DC input.
- Once the connections have been made according to your needs, connect the equipment to the mains and
switch it on. After use do not forget to switch it off and disconnect the equipment from the mains.
INPUT 1 PRIORITY
The FONESTAR amplifier mod.
MA-45RU
comes with
priority in INPUT 1 by default (ON). If you want to deactivate
priority, remove the amplifier lid and change the position
of the INPUT 1 MUTE SEND jumper on the plate on the
back panel (move from ON to OFF) (see image).
