EN
- 5 -
CONNECTION AND OPERATING
- The device has been designed to be used in closed spaces. Do not use outdoors. Place the device in a
ventilated area and on a flat surface. Remove the lid from the fog liquid deposit, fill it with certified liquid
fog and close the lid. The use of other products could damage your device.
- Connect the remote cable to the input using the DIN 5 connector in the rear part of the device. Connect
the device to the mains supply.
- The warm-up time finishes when the two red LED remote cable indicators light up. At that moment, the fog
machine is ready to be used. To activate the expulsion of fog, press the green button on the remote cable
or the corresponding button on the remote control until the required flow is reached. The red LED indicators
will go out whenever the device reaches its maximum temperature, proceeding to chill. Once the necessary
temperature is reached, the red LED indicators will light up again allowing its use.
- If the device is not going to be used for a long period of time, it is recommended that it is disconnected
from the mains supply.
SAFETY RECOMMENDATIONS
-
Do not leave the fog machine operating without liquid in the deposit, as this could cause damage to the
pump as well as the heating element.
- Do not leave liquid in the open air. Always close the fog deposit lids and the machine deposit immediately
after filling the deposit.
- Never add inflammable liquids of any type (petrol, gas, perfume) to the liquid fog.
CLEANING THE FOG MACHINE
- After approximately 40 hours use, it is advisable to clean the machine using a solution composed of 80%
distilled water and 20% white vinegar, to avoid the accumulation of residue on the device’s heating
element.
- When the device is unplugged and has cooled down, empty the machine completely. Pour the cleaning
solution into the deposit. Connect the device and wait for it to heat up. Switch the device on in a well
ventilated place until the deposit has emptied. If cleaning has finished, fog liquid can be put in the deposit
again.
FOG-11_MANUAL_(EN)_20170322_Maquetación 1 22/3/17 14:35 Página 5
