CONNECTION
- Before connecting the power supply, make sure that the volume control is at its minimum and the POWER
switch is off.
- Connect the equipment power supply cable to the mains.
- Connect a line level signal, from a mixer output, CD player, etc., to the speaker input.
- Switch the loudspeaker on using the POWER switch on the back panel.
- Adjust the input volume to the desired level using the corresponding control.
- The loudspeaker output supplies a line level that can be used as an input for another amplified
loudspeaker, mixer, amplifier, recorder, etc.
- If you hear a light buzzing in the loudspeaker audio, it could have been caused by a mass loop created
between the audio source and the biamplified loudspeaker. In this case, disconnect the earth mass by
activating the GND LIFT button on the back panel.
- When not using the equipment, switch it off: turn the volume control to its minimum, switch it off with the
POWER button and disconnect it from the mains.
- 6 -
EN
ASB-8105_ASB-12300_ASB-15300_MANUAL_(EN)_20180220_Maquetación 1 20/2/18 11:54 Página 6
