BIN • TOP-MOUNT
Horizon 710/1010/1410
11
5.5
TDS switch
5.6
Cooling Lines
CLEANER FULL
DRAIN CLOG
HIGH PRES
HIGH AMPS
SERVICE
MAINT/CLEAN
LOW WATER
TIME DELAY
SLEEP CYCLE
MAKING ICE
LOW BIN
POWER ON
CLEAN
TDS
HIGH
LOW
In
Out
§
Set the TDS switch on the elctrical box.
–
HIGH: for extended service life
–
LOW: for low-scale water
§
Install ice machine cooling water lines to docking
assembly.
5.7
Ice transport tube
5.8
Water solenoid, shut-off valve, and
potable water line options
➊
➋
5.8.1
If water solenoid is already mounted to
evaporator:
1. Insert potable water line into shut-off valve.
5.8.2
If this is an undercounter installation:
1. Mount water solenoid atop evaporator
and locate the shut-off valve
inside
the
machine. Insert potable water line into
shut-off valve.
5.8.3
If water solenoid is not mounted and
machine will not be installed undercounter:
1. Mount water solenoid to inside rear (upper
right corner) of docking assembly using
one screw.
2. Insert potable water line into shut-off
valve - locate the shut-off valve
outside
the
machine.
3. Insert outgoing line from shut-off valve into
push-in connection of water solenoid.
§
Slide ice machine into docking assembly
ensuring that drain tube is fully seated on
barbed drain fitting
➊
.
§
Insert ice transport tube into coupling and tighten
nut firmly
➋
.