18
FOLEYCO.COM
After Operation
After Operation Safety
•
Park the machine on a level surface; and make sure the brake is engaged; shut off the engine;
remove the key; and wait for all movement to stop before leaving the machine.
•
Keep all parts of the machine in good working condition and all hardware tightened.
•
Replace all worn, damaged, or missing components or decals.
Cleaning the Machine
Service Interval: Before each use or daily
1. Thoroughly wash the machine. Use a brush to remove caked-on material.
Note: Use a garden hose without a nozzle to avoid forcing water past the seals and contaminating bearing grease.
2. Use mild detergent to clean the covers.
3. Inspect the machine for damage, oil leaks, and component and probe wear.
4. Remove, clean, and oil the cylinder shafts and probes.
Important: Secure the beam with the lock levers before you store the machine for more than a couple of days.
Locating the Tie-Down Points
There are tie downs located at the front and rear of the machine.
Note: Use properly-rated straps to tie down the machine.
Hauling the Machine
WARNING
Driving the machine on street or roadway without turn signals, lights, reflective
markings, or a slow-moving vehicle emblem is dangerous and can lead to accidents causing personal
injury. Do not operate the machine on a public street or roadway.
Important: Use full-width ramps for loading the machine onto a trailer or truck.
1.
Load the machine onto the trailer or
truck (Engine forward—preferred).
2. Ensure the brake is engaged, shut off
the engine, and remove the keys.
3. Install the cylinder lock clamps
4. Lock beam in the up position.
5.
At the tie-down points, bind the
machine to the trailer or truck with
cables, chains, or straps.
AERATION
HOLES
PROBE TIP
