RCY21208
User’s Manual
Rev.: 03
Date: November 4, 2007
Page 3/8
www.foehrenbach.be
3. The process
Be sure that the crimp tool is open. If not, activate the levers of the tool till you
observe the last ‘click’. Further release the levers, the crimping die will open
automatically.
Pull the locator in its ‘load position’.
Introduce the contact. Push the contact till it reaches the hard stop.
Push the locator towards the crimping die. A magnet will keep the locator in
position.
Attention! This is only possible when the crimping die is open.
