5
Product Overview
Setting Up
Step 1:
Place the vaporizer on a flat surface and in a suitably large area with at least 50 cm of open
space around the machine.
Step 2:
Fill the fluid tank with
Fog Defense
Antibacterial Solution.
Step 3:
Connect the machine to a suitably rated power supply. To determine the power requirement
for the machine refer to the label on the back of the machine.
Always connect the machine to a protected circuit and ensure it is properly
grounded to avoid risk of electrocution.
Step 4:
Turn on the machine and allow it to heat up, while the machine is heating up the LED status
light on push button will flash. Heat up takes approximately 2 minutes. Once machine reach
operating temperature, the LED status light will turn solid.
Step 5:
To start making fog, press the push button located on the handle. Press the push botton
again to stop
Step 6:
To turn off the machine, put the power switch to
OFF
position.
Wireless receiver
(antenna)
Manual ON/OFF
switch
Fluid tank
Power switch
Fuse
Tank cap
Power cord
Be sure to either put the smoke detectors in test mode or disconnect your
smoke alarms entirely before operating the vaporizer
.
