T R O U B L E S H O OT I N G
Hardware does not power up
• Is the unit connected to the computer using the supplied Firewire cable?
• Is the computer powered up?
• Is a correct Firewire cable in use? Some have shorter connections at either end that may not be making
contact with the computer/hardware.
Software does not appear in my plug-in list
• Has the Installer on the Resources disk been run?
Compressor doesn’t work
• Is the Comp On switch engaged?
• Is the Compressor Threshold set sufficiently low? Only when the signal reaches the Threshold will
compression begin.
• Is the Ratio dial turned up? The signal will only compress if a ratio other than 1:1 has been set.
Can’t hear the EQ
• Is the EQ On switch engaged?
• Is the Band On switch active for the band in use?
• Is the EQ Output turned down?
Can’t select EQ bands using the hardware?
• Is the band trying to be selected empty? The data encoder must be pressed and held, then rotated whilst
held down for empty bands to be selected.
Can’t open up 32 mono plug-ins
• Are you working at a sample rate above 44.1/48kHz? Liquid Mix only processes 32 channels at 44.1/48kHz.
At sample rates above that, the number decreases to 8 and 2, at 88.2/96kHz and 176.4/192kHz respectively.
The Liquid Mix is bringing up buffer error messages in Logic
• The Processor Buffer must be set to Low or Medium for the Liquid Mix to work. A high Processor Buffer
setting will not work.
Summary of Contents for Liquid Mix
Page 1: ...U S E R G U I D E Rev 1 0 ...
