5
©
202
1
Focal Point Fires Ltd.
This product has one non-self-resetting overheat protection device (thermal cut-out) which will activate if the air inlets or out-
lets are obstructed. For safety reasons the fire will NOT switch on again automatically, the following procedure must be carried
out before the fire can be operated.
NOTE: The visual effect will remain operational if the cutout is activated, only the fan heater is prevented from working.
Switch OFF the appliance
at the wall socket or outlet.
Leave the fire OFF for a period of no less than 10 minutes, ensuring all
obstructions are removed. Switch the appliance ON
at the wall.
Ensure the appliance is turned ON at the control switches. If
the fire fails to operate correctly, repeat the above procedure. If an attempt to switch on the appliance is made before the safe-
ty cutout has reset, the appliance may cutout for a further period of time. If the sequence has been followed correctly and the
appliance still fails to function, check the fuse in the wall outlet. If this is not the cause, call an electrician or maintenance engineer.
7.0 SAFETY CUTOUT SYSTEM
MANUAL OPERATION
• The switches are locate
d
behind
the
front door of the appliance. The standby switch (2) must be switch
ed
on.
• Press the O/I button (3) once to turn the heater and flame effect
on
. A red indicator light will appear to indicate that the
function is ON. Press the O/I button for 3 seconds this will operate the dimmer mode to adjust the desired flame
brightness setting.
• Press the 900W button (4) once for the low heat settings; press twice to switch the heat setting
off
.
• Press the 1800W button (5) once for the high heat settings; press twice to switch the heat setting
off
.
• Rotate
the
thermostat
control
knob (1) clockwise or anti-clockwise to increase or decrease desired room temperature
setting.
• NOTICE: The heater will only work if
the standby switch (2) and the
O/I switch (3) is ON and
the
thermostat (1) is set
above
the
current room
temperature.
6.0 OPERATING THE APPLIANCE
- CONTI
NUE
D
GB IE
REMOTE CONTROL
• The standby switch (2) located behind
the
front
door of
appliance
must be switch
ed
on.
•
There might be a slight delay
for the receiver to respond to the
transmitter. Do not PRESS the buttons more than once within
two seconds for
the
correct operation.
• Press the ON/OFF
button
(1) once on the remote control
,
this
turns
the heater and the flame effect
ON/OFF.
• Press the 900W button (2) once for the low heat settings; press
twice to switch off the heat setting.
• Press the 1800W button (3) once for the high heat settings;
press twice to switch off the heat setting.
• Press the DIMMER button (4) for operate the dimmer mode to
adjust the desired flame intensity.
•
NOTICE: The heater will only work if the standby switch (2)
and the O/I switch (3) is ON and the thermostat (1) on the
control panel is set above the current room temperature.
