5
'
2014 Focal Point Fires plc.
8.0 FITTING THE DECORATIVE FRAME AND FRONT
The appliance may be supplied with a decorative frame in a variety of finishes.
IMPORTANT : Due to the possibility of sharp edges, care should be taken when handling the frame components. The use of
protective gloves is recommended.
If not pre-fitted, and the appliance is supplied with a one piece decorative frame that is attached to the front of the firebox with the magnets
provided. Place the decorative firefront in front of the fire and slide the ashpan door into place. The firefront shown in these instructions may
be different to the one supplied with the appliance.
For three piece frames : The side pieces of the clip on assembly should be pushed into position first, followed by the top bar, which overlap the
sides.
Cast frame models: Remove the decorative frame from it’s protective packaging. The frame is retained onto the firebox with a mounting
bracket at the top of the frame and three magnets on each leg of the frame.
8.1 FITTING THE LOOSE FUEL BED OPTIONS
IMPORTANT: Loose fuel bed options are only available with the Lulworth model.
The Lulworth LED inset electric fire has the option of either a real coal or pebble fuel bed. Simply
remove the coals or pebbles from their packaging and position the coals or pebbles onto the plas-
tic fuel bed.
7.0 REMOVING THE APPLIANCE SPACER FRAMES-CON
GB IE
Step 3: Remove the outer spacer frame.
Step 4: To remove the second spacer unscrew four screws using same method used in steps 1,
2 & 3.
