Model 922-MES
– User Manual
Focal Technologies Corporation
Page 6-3
A Moog Inc. Company
Document No. 922-0662-00, Rev 1.0
6.2 Diagnostic LEDs
The table below describes the on-board diagnostic LEDs on the card. LEDs are intended for bench level
verification as typical status from installed equipment is accessed via Ethernet.
Table 6-1: On-Board Diagnostic LEDs
LED
LED Name
Note
D2
SFP2 LOS
1
D3
SFP1 LOS
1
D5
POWER
2
D6
SFP1 LINK
3
D7
SFP1 ACTIVITY
4
D8
CU1 LINK
3
D9
CU1 ACTIVITY
4
D12
SFP2 LINK
3
D13
SFP2 ACTIVITY
4
D14
CU2 LINK
3
D15
CU2 ACTIVITY
4
D16
CU3 LINK
3
D17
CU3 ACTIVITY
4
D18
CU4 LINK
3
D19
CU4 ACTIVITY
4
D20
CU5 LINK
3
D21
CU5 ACTIVITY
4
D22
CU6 LINK
3
D23
CU6 ACTIVITY
4
D24
CU7 LINK
3
D25
CU7 ACTIVITY
4
D26
CU8 LINK
3
D27
CU8 ACTIVITY
4
Notes:
1. Green: ON Solid = No loss of optical signal (No LOS). OFF = Loss of optical signal (LOS)
2. Green: ON Solid = Board is ON. OFF = Board is OFF.
3. Yellow: ON Solid = Ethernet Link Up. OFF = No Ethernet Link
4. Green: ON Solid = Ethernet Link Up. Blinking = Ethernet TX/RX Activity. OFF = No Ethernet Link.
6.3 Jumpers
The table below describes the hardware jumpers on the card.
Table 6-2: Hardwire Jumper (as-built)
Jumper
Name
Note
JP1
FACTORY USE
OPEN: Default
JP2
uC DIAG
CODE RESET
This jumper is only checked by the software on power up.
OPEN (default):
Diagnostics uC runs in normal operation.
SHORTED:
Revert uC DIAG firmware to factory version.
JP3
FACTORY USE
SHORTED: Default
JP4
FACTORY USE
SHORTED: Default
D16
D5
D7
D9
D17
D18
D19
D20
D21
D22
D23
D24
D25
D26
D27
D13
D15
D6
D8
D12
D14
D2
D3
