Controlling the
LCD display panel
LCD on/off control: The LCD
display may be switched on and
off independently of the heater
functions by using the LCD on/off
button as shown in figure 14.
Scene select buttons: The
appliance is pre-programmed
with nine different scenes as
shown in figures 5 through 13.
These scenes have been specially
edited to run in a seamless loop.
When the appliance is switched
on, the log fire scene will auto-
matically run. To select a different
scene press the appropriate
scene select button to choose
the desired scene. During normal
operation the footage may occa-
sionally be seen to ‘freeze’ for a fraction of a second. This happens as the scene is recycled
to loop again. This is perfectly normal and should be no cause for concern.
Volume up, down and mute button: Some of the LCD scenes include sound effects.
These buttons raise and lower the volume. The Mute button mutes the speakers. While the
speakers are muted, a symbol will be displayed on screen. Press again to de-activate.
The appliance can be switched off at any time, irrespective of the particular
mode selected, by simply switching the first switch marked (OI) to the “off”
position. It is also recommended to unplug the power supply cable at the supply
outlet when not in use.
5
©
2015 Focal Point Fires plc.
Fig. 11 - Abstract scene
Fig. 12 - Nature scene
Fig. 13 - Aquarium scene
Fig. 8 - Gas fire (medium)
Fig. 9 - Gas fire (high)
Fig. 10 - Gas fire (Blue Flame)
Fig. 5 - Log fire
Fig. 6 - Twig fire
Fig. 7 - Coal fire
Scene
select
buttons
Volume
and
mute
buttons
Figure 14
LCD
on/off
control
Controlling the heater functions
The first switch marked (0I), controls the main power to the appliance and switches on the LCD display panel. This feature can be used inde-
pendently of the heating features.
The next switch, marked (
*
) operates the fan blower without heat, and can be used for cool air circulation. However for this feature, the
main power switch (0I), must also be in the “on” position.
The next switch, with a “single bar” marked (I) operates the low heat, (1000W/ 1.0KW) setting.
The next switch, with “two single bars” marked (II), operates the high heat, (2000W/ 2.0KW) setting.
To operate the fire in any of the above modes, the top switch marked (OI) must be switched to the “on” position.
To operate the fire, the (OI) switch must be on, followed by the (
*
) switch to start the blower. To obtain heat from the appliance, the
blower must be on and the I switch must then be operated for LOW heat, followed by the II switch for the HIGH heat setting.
Read All Instructions Before Use
Check that the heater outlet grille, mounted at the top of the appliance, is not covered or obstructed in any way, and ensure the power to the
fire is switched on. The power to the LCD display panel and the heater functions are controlled using four switches mounted on the bottom
of the appliance. The fire can be turned off by just unpluging the power cord.
9.0 OPERATING THE APPLIANCE
GB IE
