MPA-‐2 Operating Manual Ver. 1.2 2016
5
Safety Information
Please observe the rear panel fuse rating and replace with the same type and rating
fuse.
Set the correct operating voltage prior to applying power the MPA-2.
If replacement fuse blows return the MPA-2 for service. Do not install larger fuse. This
will case damage to the unit as well as possible harm to the user.
Do not expose the MPA-2 to moisture, this could cause damage to the unit and cause
harm to the user.
Do not allow fluids to leak into the top lid vent slots. Damage to the unit will occur.
There are no user replaceable parts inside.
Do not attempt to service the MPA-2. There are dangerous voltages inside the unit.
Do not cut the U ground (3
rd
pin) on the AC cord. This could cause harm to the user.
Avoid blocking the top and side vents of the MPA-2. This could cause the unit to heat
up and cause possible failure.
If rack mounting the unit use all 4 front panel rack mount holes. The MPA-2 is heavy
and may sag in the rear if all 4 screws are not used. Use fiber washers under the
screws to prevent front panel damage and scratching to the front panel anodize
plating.
