background image

8

©

2018 Focal Point Fires plc.

Fire is not switching on

Ensure mains switch is on

Replace the fuse in the plug

Fire is not emitting any heat

The fire is fitted with an energy saving thermostat. If the temperature in the room 

is higher than the temperature selected on the fire, then the thermostat will stop 

the heater from turning on. For example, if the room temperature is 22ºc or above

and the fires heater is set at 22ºc, then the heater will not be required until the 

room temperature drops below 22ºc. If this is the case select a higher temperature

setting than the room’s temperature and the heater will begin to operate.

Fire shuts off after a period of time

Check that the temperature is not set onto the lower settings.  If the room is 

warm enough the thermostat will stop the fire switching the heat on.

Check that the chimney/flue is blocked off.

Clean inlet and outlets out with a vacuum cleaner.

Fire seems noisy

There is a level of noise when the flame effect is in use, caused by a motor that 

helps generate the effect. This noise will be heard when there is no other 

background noise.

There is a higher level of noise associated with the heater motor; this is due to 

the air flow required when heat has been selected.

Remote is not operating

Check or replace batteries.

14.0 TROUBLESHOOTING GUIDE

GB IE

15.0 GUARANTEE - TERMS AND CONDITIONS

The 3 year guarantee only covers products purchased on or after 1st February 2009. For all gas fires purchased the 3 year guarantee

commences from the date of purchase, provided that the following 3 terms and conditions are adhered to:

Registration is not required. 

1. For any claim to be made within the 3 years from date of purchase you will be required to provide and supply us with your proof

of purchase.

2. Your gas fire must have been commissioned by a Gas Safe registered installer, evidence of which you must provide together with the

Gas Safe registration number.

3. Your appliance must have been serviced annually, irrespective of use, by a Gas Safe registered installer, evidence of which must be

provided, such as the receipt.

Please note all consumable items such as any ceramics including; coals, pebbles, the matrix, front strips, side cheeks, rear panels and

tapered rear panels are not covered by the 3 year guarantee.For all Electric fires purchased the 3 year guarantee commences from

the date of purchase, providing that you can supply the proof of purchase. This does not cover consumable items such as pebbles,

coals or light bulbs.

Making a claim is easy. 

If you wish to make a claim under our 3 year guarantee and all the terms and conditions for your product have been met then please

submit the following information for the attention of the 3G Service Department to the address below. Alternatively, you can email or

fax.Please note that this does not affect your statutory rights.

Focal Point Fires plc, 3G Service Department, Reid Street, Christchurch, Dorset, BH23 2BT. 

Alternatively email: [email protected] or fax. 01202 499326.

Details required: 

1. Name, full address including post code and contact telephone number.

2. Receipt of purchase or credit card statement.

3. Original installers CORGI/Gas Safe* registration number (gas fires only).

4. Annual service receipt for every 12 months (gas fires only).

F8

61

37

0

As our policy is one of continuous improvement and development, we therefore hope that you will understand we must retain the right to amend details and/or specifica-

tions without prior notice.

Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice.

Summary of Contents for LEIRVIK EF09-19









Reviews: