©2003 FoamFly.com
19
g) Cut/Gouge/Sand out a groove along the length of the Bamboo next to
the hole. In one direction.
h) Test fit the wire to ensure that it fits into the groove.
i)
Cut the Bamboo to the length shown, and slightly taper the non-grooved
end.
j)
Point the bend at the end of the wire through the hole, and run the wire
down the length of the groove.
k) Sand the wire to that the point doesn’t stick out past the Bamboo.
l)
Test to see of the combo is a tight fit in the Aluminum tubing.
m) If all is well, glue the wire into the Bamboo.
n)
o) That’s it. Fit the wheel on to the axle, and insert the entire mechanism
into the tubing whenever you want to use landing gear. The Nosewheel
gear should be a tight fit in the tubing. Make sure the wheel is pointing
the right direction when you install the gear each time.
You’re still reading? Go fly already. ;)
Enjoy your Staggerwing. Share photos if you can, and don’t hesitate to get in
touch if you have questions, or need help setting up your plane.
Sincerely,
-Dan
[email protected]
