©2006 FoamFly.com
6
b) Put the horizontal stabilizer into the slot in the tail. Hot Glue Weld the
horizontal stabilizer into place. (See Appendix Section, “Hot Glue
Welding”)
c) Fit the wings into the fuselage. Put one wing into the slot until it is
halfway through. Get it positioned right, and hot glue weld it in place.
d) Get ready. Squeeze some hot glue into the wing slot from the other
side, and then put the opposite wing in place quickly. Align the two
wings to be even, and with the correct dihedral as shown, then Weld
them in place along the seam where they meet the fuse.
e) Install the servos.
i)
Position the servos where they will have the easiest path to the
receiver and control surfaces. Cut a hole through the plane, insert
the servo and wire, and use the hot glue gun to “rivet” them in
place.