4
Operation
1 .
Follow all instructions from the chemical
manufacturer and fill the tank with a ready-to-
use solution or mix to the chemical manufacturer
instructions.
Important!
Do not spill the solution on
the air compressor.
2 .
Plug the unit in to a 120 VAC GFCI protected
power outlet.
3 .
Turn the power switch ON to start the air compressor.
4 .
Set the pressure setting to 85 psi.
5 .
Verify that the air shut-off valve at the trigger gun is
in the closed position and open the air inlet valve on
the back plate.
6 .
On model MU-AC-15-PSGN130:
Point the discharge wand in a safe direction and
open the air shut-off valve at the trigger gun.
Then squeeze the trigger handle to begin misting.
Note:
Both discharge valves should be completely
open while misting.
On model MU-AC-15N:
Point the discharge wand in a safe direction and
press the red and blue discharge trigger buttons at
the same time to begin misting.
Note:
Both discharge
buttons should be completely open while misting.
7 .
On model MU-AC-15-PSGN130:
To stop misting, release the trigger handle and the
close the air shut-off valve.
On model MU-AC-15N:
To stop misting, release the red and blue discharge
trigger buttons.
V20200501
•
Page 9 of 14
Model: MU-AC-15N, MU-AC-15N-PSGN130
2
5
6
6
3
4
Open
PSG12 trigger
RAC-GUN-.5 red and blue buttons
Close
5
