FMUSER INTERNATIONAL GROUP INC.
广州市汉婷生物技术开发有限公司
12
5.5.7 Windows control software - First steps
1.
In the case of USB connection install the USB driver first. Pure RS232 connection requires no driver.
2.
Make sure the RDS encoder is connected and powered, all connectors are seated completely and
where possible, use screws to fix the connection.
3.
Open the Preferences (Options - Preferences) and set up the connection parameters. If the RDS encoder is
connected via USB and was recognized correctly in Windows, you may find/change the COM port number in
Windows Control Panels - System - Hardware - Device Manager.
4.
Close the Preferences. You should see "Connected" or "Opened" in the status bar. Now you are ready.
The settings are saved automatically.
5.
Configure the basic RDS settings mentioned above. You will find them on cards Program and System.
Then click Store.
6.
The status bar at the bottom of the window shows whether the data was sent successfully. If Communication
Error! is shown, check the connection to the RDS encoder, its power supply and that the correct COM port is
selected in the Preferences dialogue box.
7.
Follow the instructions in the application Help.
Magic RDS 3 - default Windows control software.
Download the Software here:
http://a.fmuser.com/upLoad/product/month_1507/20150702112154software-of-FMUSER-RDS-C-encoder.rar
Note: The RDS encoder contains two types of memory. These are marked as RAM and EEPROM. Like any other
computing system the RAM holds all operational data which are also used for transmission whilst the EEPROM is
used for the data storage during power-off. By default the button Send will fill the RAM only. The button Store will fill
the RAM and also stores the data into EEPROM. The Store button behavior can be changed in Options -
Preferences - Buttons.
If the user forgets to store the data into EEPROM, the settings will be lost when the power is disconnected.
