Operating Manual EMGZ421
7
5
Quick installation guide
•
Check all your requirements such as:
– configuration of the analogue outputs (signal level)?
– gain switching required?
– linking by serial interface etc.?
•
Draw your final wiring diagram according to the wiring diagrams (refer to „7.3 Wiring
diagram variant for insert card support block“ / „7.4 Wiring diagram variant with
separate housing“)
•
Install and wire all your components (refer to „7. Installation and wiring“)
•
Parametrize and calibrate the measuring amplifier (refer to „8.2 Calibrating the
measuring amplifier“)
•
Put system into operation; proceed a test run with low speed
•
If required, do additional settings (refer to „8.3 Additional settings“)
Summary of Contents for EMGZ421
Page 31: ...Operating Manual EMGZ421 31...
