www.fmiproducts.com
106625-01F
6
FIREplacE accESSORIES
GLASS DOORS
Bifold glass doors are optional with FMI
PRODUCTS, LLC fireplace. For replacement,
refer to fireplace installation instructions in
your owner’s manual.
Note: Use of glass doors other than those
manufactured by FMI PRODUCTS, LLC
voids warranty and may create a potentially
hazardous condition.
Refer to installation instructions that come
with door kit for installation details. Glass door
kits can be installed before, during or after
fireplace has been installed.
4. Air from bottom grill (circulating units only).
Make sure fireplace enclosure and base
have been insulated according to cold
climate installation instructions in owner’s
manual.
Note: After all measures to avoid cold air
drafts have been taken, there may still be
a slight cold air draft coming through the
louver and other areas. This may be due to
circumstances beyond the manufacturer’s
control, such as airflow around the structure
and tightness of the home (creating negative
pressure), etc.
ASH DISPOSAL
Ashes should be placed in a metal container
with a tight fitting lid. Closed container of
ashes should be placed on a noncombustible
floor or on the ground. The container should
be kept well away from all combustible ma-
TROUBlESHOOTING
Continued
terials pending final disposal. If ashes are
disposed of by burial in soil or otherwise
locally dispersed, they should be retained in
closed container until cinders have thoroughly
cooled.
GLASS DOORS
Glass doors used by FMI PRODUCTS, LLC
are tempered (safety) glass and have been
tested to national standards. When glass
breaks during use it could be for the follow-
ing reasons:
1. Fire is too large
2. Logs are too close to glass. Logs and any
burning material should not touch glass.
This may cause glass to break.
3. Heat has built up too fast.
Continued operation at excessively high tem-
peratures may cause glass to partially lose it's
temper and break.
GAS LOGS
A full line of vented and vent-free FMI
PRODUCTS, LLC gas logs is available.
See your dealer or distributor for details
or visit
www.fmiproducts.com
.
FANS/BLOWERS
This accessory is designed to enhance the
convection principle (see
Air Circulation
, page
3). It is not designed as a blowing system.
cUSTOMER SERvIcE
You may have further questions about instal
-
lation, operation or troubleshooting. If so,
contact your dealer or distributor. If further
help is needed, contact FMI PRODUCTS,
LLC at 1-866-328-4537. When calling please
have your model and serial numbers of your
heater ready.
Note: The serial number and other pertinent
information can be found on the rating plate
located behind the screen near upper right
corner of firebox. In some models it may be
located vertically on side panel.
You can also visit our web site at
www.fmiproducts.com.
