D.210.000.V1
En-13
OUTLAND LIVING - PRINCETON 2-BURNER STOVE OWNER & SAFETY MANUAL
SUMMERLAND
Owner & Safety Manual
PRINCETON
2 BURNER GAS STOVE
WARNING:
Never perform inspections, cleaning or maintenance when
the appliance is hot! The stove must be cool and the LP
cylinder disconnected BEFORE any cleaning or inspection and
maintenance is performed.
SECTION 8:
APPLIANCE MAINTENANCE
Your Outland appliance requires periodic maintenance to keep it in good running order. Follow the steps below to ensure your appliance
will provide you with the best possible performance:
1. Keep your appliance out of the rain and store it in a dry place.
2. If the appliance has been left out in the rain uncovered tilt the appliance to drain any water accumulated in the burners and/or burner
compartment prior to ignition.
3. Should any part of this appliance (including the burner) become soiled or dirty, wipe lightly with a damp cloth.
4. Ensure that you clean the top of your Outland appliance after every use to keep it looking GREAT.
5. Simply use warm soap water to wipe down your appliance to keep it clean.
6. Do not use flammable or corrosive cleaning products on or near this unit.
7. Do not use abrasive cleaners.
GUIDELINES
• Keep appliance area clear and free from combustible materials, gasoline and other flammable vapors and liquids.
• Do not obstruct the flow of combustion and ventilation air.
• Keep the ventilation opening(s) of the cylinder enclosure free and clear from debris.
• The stove must be cool and the LP cylinder disconnected BEFORE cleaning or inspection and maintenance is performed.
BURNER & ORIFICE INSPECTION
Visually inspect the cast aluminum burners prior to each use.
The burners are located in the stove inner compartment.
TO ACCESS AND CLEAN THE INTERIOR STOVE COMPARTMENT
1. Allow stove to cool.
2. Ensure all appliance valve(s) are off and the cylinder valve is closed.
3. Disconnect the gas cylinder.
4. Remove grill locking pins.
5. Lift grill.
6. Clean the stove inner compartment area.
7. Clean any plugged gas jet orifices with a small pin or paperclip.
8. Close the grill. Ensure the (2x) grill locking pins are fully seated.
WHEN CLOSING GRILL ENSURE BOTH 2X GRILL LOCKING PINS ARE FULLY SEATED.
THE BALL BEARING ENGAGEMENT SHOULD BE VISIBLE ON THE OTHER SIDE.
Locking Pin
Grill
