39
Mod. B4600Humid
Change door opening.
(Only RXL series)
The ovens with an open side door, you can change the opening direction of the same, for this operation
please fallows the next steps:
1. Remove the head screws, which are holding the hinges.
2. Once subtracted the hinges, insert the screws in the same holes.
3. Rotate the door 180
⁰
and place along with the hinges on the new position.
Note:
Do not fully tighten the hinge screws until you have properly not adjusted the door in position.
12. FREQUENTLY ASKED QUESTION
When you finish the work with the device disconnect from the network, wait for cooling during 30 minutes
and clean the chamber and trays with soap and water.
DO NOT USE water directly at the device; it can cause damage in the components
Below is a list of causes / failures / and solutions.
FAILURE
CAUSE
SOLUTION
The device not start
Lack of voltage
Check voltage
Inadequate network connection
Verify network connection
Thermostat not working
Consult with the technician
Timer not working
Consult with the technician
Safety switch not working
Consult with the technician
Safety thermostat intervenes
(except RX404,RX304, RX424)
Reset the thermostat at the front. If
the problem persist consult with the
technician
The device is not
cooking properly
Fan not working
Consult with the technician
Element not working
Consult with the technician
Grill not working
Consult with the technician
Humidifier not working
Consult with the technician
Relay not working
Consult with the technician
Turning inverse not working
(except RX404, RX304,RX424,
RX484)
Consult with the technician
Thermostat not working
Consult with the technician
Timer not working
Consult with the technician
The chamber lights
are not turn on
The lamp is not tight
Tight the lamp
Lamp melted
Change the lamp
Steam leaves when
the door is closed
Misplacement of the door gaskets
Place it well. If the problem persist
consult with the technician
Misaligned door closes
Consult with the technician
Summary of Contents for M603
Page 40: ...40 ...
