SHIPPING INSPECTION
Remove from shipping container and inspect for shipping
damage. The VDA414/C is a Slide in Card that fits into the
RMS-400 Mainframe and Power Supply. The card is supplied with a
retaining screw (attached to the PC Board), a Front Label
Designator and this instruction book. If an RMS-400 Mainframe and
Power Supply have been purchased with Card, the Card will be
installed into the Mainframe with labels attached and the
retaining screw engaged and locked.
HOW AND WHERE TO MOUNT THE UNIT
Select a position for the RMS-400 that is near the
video signal or other equipment that needs video distribution. The
placement is not critical. Then install the VDA414/C PC CARD in
any unused CARD SLOT that is empty. Follow the instructions for
card installation, be sure not to apply excessive force to the
card during installation.
MODULE CARD INSTALLATION
1.
Select one of the un-used nine positions to be occupied by
the new circuit board module.
2.
Remove the blank label in that position by peeling it off of
the front panel. Peel the label slowly to remove all of the
label and adhesive. Any remaining adhesive may be removed by
rubbing the surface with your thumb. WARNING DO NOT USE
SOLVENTS TO REMOVE THE LABEL ADHESIVE. The solvent could
damage the equipment cards or cause a fire.
3.
Peel the backing off of the new label and apply it to the
front panel of the RMS-400 rack in the position of the new
card. Align the new label with the screw head in the hole in
the lower right hand corner of the label, and then align the
center thumbscrew with the clearance hole in the front panel.
This should cause the label to be straight and vertical. When
the label is in place press firmly the secure the label.
4.
Then remove the thumb-screw retainer from the product card,
it is located at the front of the card and is removed by
rotating the knob counter-clock-wise.
5.
Select any and all product options on the specific card.
6.
Next slide the card into the card guides at the rear of the
RMS-400. Be sure that the notch in the circuit card is facing
forward and down. Push the card all the way to the front of
the rack until it stops. DO NOT APPLY EXCESSIVE FORCE TO THE
CARD.
VDA414C.ISB
Page 2 of 5