Push any LEDs (Light Emitting Diodes) straight into the appropriate mounting
holes. (See instructions for the particular module being installed). Insert only until the
dark collar around the colored LED is flush with the front panel, the collar must not
protrude, in order to avoid interfering with the new nameplate.
Mount the new front panel nameplate (Furnished with the circuit board module
being installed). Temporarily set the new nameplate in place and check that all
necessary cutouts are clear. Remove the paper peel coat from the adhesive baking
of the nameplate, then slide the nameplate down around the LEDs onto the panel.
Press gently to set the adhesive.
Mount any additional panel components (switches, meters, potentiometer, etc.)
with the hardware supplied. Gently tighten the fastener to secure the components,
do not over tighten the hardware.
Mount the new rear panel connector identification strips as illustrated in the
instruction book for the particular module being installed. Connect input, output, and
power cables. The green “POWER ON” indicator should be illuminated. Set any
internal controls as required.
CAUTION:
Most circuit board modules have several adjustments which are carefully
factory set with precision instruments for optimum performance. Change only those
which must be adjusted, some control when misadjusted produce little change under
normal operating conditions, but can seriously reduce the ability of the unit to
function correctly under other conditions which may be encountered. Therefore, if
you must adjust a control, place a mark on it before moving it, so that it may e
returned to its original setting with reasonable accuracy.
Disconnect power. Replace top and bottom covers and mount mainframe to
rack. Reconnect power and check for normal operation of each module.
FMU622CAisb
page
19
of
19
