6
❑
7. Move the fl ap switch on the transmitter to the "0"
position.
❑
8. Position both fl aps so that they are in the up
position, then tighten the screw-lock connector on the
fl ap pushrods.
❑
9. Check the fl ap throws to make sure there is no
binding.
!!! WARNING !!!
Set the Failsafe
With electric planes, once the motor battery is
connected to the ESC the motor can come on at
anytime causing damage or serious injury. If the failsafe
is not set and the transmitter is switched off before the
motor battery is disconnected, the motor could come
on. Review the instructions included with your radio
system for setting the failsafe.
This procedure must
be done with the propeller removed.
Setting the Tactic TR625 receiver failsafe:
❑
1. Switch on the transmitter and connect the motor
battery to the ESC.
❑
2. Make sure the throttle stick is down.
❑
3. Press and hold the “Link” button on the receiver
until the red LED goes out and then release the button
and the red LED should come back on.
❑
4. Check the failsafe operation. To arm the motor the
throttle stick must be in the down position. If the throttle
stick is not, the motor will beep. Once the throttle stick
is moved to the down position the motor is ready to run.
With the transmitter switched on and the motor battery
connected, move the throttle stick so that the motor is
running slowly. Switch off the transmitter and the motor
will stop if the failsafe is set correctly. If it does not stop,
repeat the failsafe setting procedure.
Finish the Assembly
❑
1. Separate the four servo wires coming from the wing
and tape together the remaining wires.
❑
2. Place the receiver at the back of the radio compartment.
Position the receiver antennas and tape into place following
the radio manufacturer’s recommendations.
