Your Aero Scout should not be considered a toy, but
rather a sophisticated, working model that functions
very much like a full-size airplane. Because of its
performance capabilities, the Aero Scout, if not
assembled and operated correctly, could possibly
cause injury to yourself or spectators and damage
to property.
1. Operate the plane according to instructions.
DO NOT alter or modify the model. If you make any
modifications, you void your warranty.
2. Test the operation of the model before each flight
to insure that all equipment is operating properly and
that the model remains structurally sound. Be sure to
check clevises or other connectors often and replace
them if they show any signs of wear or fatigue.
3. Fly only on calm days (with wind speeds less
than 5mph) and in large open areas free of trees,
people, buildings, or any other obstacles.
4. If you are not an experienced pilot or have not flown
this type of model before, we recommend that you get
the assistance of an experienced pilot in your R/C
club for your first flights. If you’re not a member of a
club, your local hobby shop has information about
clubs in your area whose membership includes
experienced pilots. You can also contact the National
Academy of Aeronautics (AMA) which has over 2,500
chartered clubs across the country. Instructor training
programs and insured newcomer training are
available through any of these clubs Contact the AMA
at the following address or toll-free phone number:
Academy of Model Aeronautics
5151 East Memorial Drive
Muncie, IN 47302-9252
Tele. (800) 435-9262
Fax (765) 741-0057
Or via the Internet at: www.modelaircraft.org
The R/C model hobby becomes more and more
enjoyable as your experience grows. Your chances
for success and graduation to higher levels are very
good if you take your time and follow the flying
instructions carefully and completely. We hope you
enjoy flying your Aero Scout plane.
• Nickel–Metal Hydride (NiMH) Battery:
Rechargeable batteries which are used to power
the airplane. NiMH batteries are lighter and smaller
that most other types of rechargeable batteries.
• Transmitter (TX): This is the hand-held unit that
sends the signal to the control unit, or RX.
• Rudder: Controls direction.
Power
LED
Ch
a
rge
Indic
a
tor
LED
Power
S
witch
Antenn
a
Ch
a
rge
B
u
tton
R
u
dder
Control
Antenn
a
Throttle
R
u
dder
Control
GLOSSARY
PRECAUTIONS
2
FCC REQUIREMENT
Carrier Frequency: 27.145MHz
Carrier Frequency: 49.680MHz
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modifications to this product not expressly approved by the party responsible for compliance
may void the user’s authority to operate the equipment.
