Flywoo CINERACE20 CADDX POLAR NANO HD, Manual

Page: 8 / 16

FLYWOO CineRace20 DJI HD V1.0
turn off the power, and then repeat again the above steps. When the RX is powered on
for the third time, the LED light will start to double-flash, which means that the RX enters
the binding mode
- Insert the 2.4G ELRS TX to Radio transmitter, and choose External RF mode to CRSF
protocol, then you can find ELRS menu from the Radio systems(Need to copy the
ELRS.LUA file to the SD-Card tools first), Enter into ELRS and press [Bind], the LED on the
RX module will getting to be solid if bind successfully.
- Receiver LED status meanings:
EL24E/EL24P RX: LED solid means bind successful or Connection established; LED
double-flash means in bind mode; LED flash slowly means no signal connection from
the TX module; LED flash fast means in WIFI hotspot mode, you can connect the WIFI of
the RX and upgrade firmware of the RX via visit 10.0.0.1 from the web browser(password:
expresslrs)
R9MM FCC ACCESS OTA：
Make sure your remote control supports ACCESS protocol, then follow the link to
register and bind
https://www.youtube.com/watch?v=az5hDdNBcjg&t=9s&ab_channel=FrSkyRC
If the remote control is ACCST protocol, please bind as follows:
1/ Put these two files into the firmware directory of the SD card of the remote control.
R9MM firmware: FW-R9MM-ACCST_v20190201
R9M TX module: FW-R9M-ACCST-20190117
2/ Insert the R9M TX module and write the firmware you need