19
Assembly the steel wire and wheels
(see picture for detail C)
6
Glue the rudder to the fuselage with PU. The rudder
must be verticaly.
Glue the
to the fuselage with PU.
rear cover
Cut the front cover to the three parts and their outside
glue to the fuselage with PU. To the front part cut slot for
engine.
Glue the horns 18 to the rudder and elevator.
Insert servos in holes. Cut slots for pushrods
tubes. The pushrod tubes should remain straight
so the slots must be cut properly. Bend one end
of the pushrod to "Z" shape.
Mount the pushrods trought tubes to the rudder
and servo horns, adjust the proper lenght of
pushrod to bring the control surfaces into the
neutral position and screw up of the snap 27 the second end
of the pushrod. Glue the pushrod to the fuselage.
10
18
B
Glue tail skid 22 with CA to the fuselage.
Cut canopy 11 of the stamping and glue to the fuselage
with CyA. Glue motor mount 19 to the fuselage with PU
Mount ailerons servo to the fuselage. Glue horns 18 to the ailerons. Mount pushrod tubes. (follow
instruction 4 and 5 obove)
The lower part view on the ailerons servo without the lower cover.
Page 5
c
10
27
A
2
3
23
11
6
RX
REG
BAT
A
B
4
22
B
B
19
18
18
10
