EN
GL
ISH
8
SA
FE
Ty
S
yS
TE
M
04 SAFETy SySTEM
Our SIMPLE Quick Release system is fully
functional in temperatures down to -5 ° C or
23 ° F. Their function below -5 ° C or 23 ° F
temperatures is not guaranteed.
To avoid operating errors, knowing everything about handling
and functions of the Quick Release is essential; carefully study
the operating instructions of the respective control bar.
Before kiting, check the Quick Release sys-
tem (QR) for functionality and perform a test
release. The QR must not be dirty or frozen to
ensure full functionality. No leashes or lines
may be wrapped around the QR. The Quick
Release systems by FLYSURFER are designed
to be used with harness hooks.
Each FLYSURFER Control Bar is hooked into the harness hook
with the help of the chicken-loop, located below the Quick Re-
lease, and secured to the harness hook with the chicken-stick.
Before every start, ensure the chicken-loop is correctly fas-
tened to the harness hook.
QR3
05 QUICK RELEASE
05.01 Activating a FLySURFER Quick Release
To detach yourself from the kite in an emergency, the orange
release handle simply needs to be pushed away from the body.
This will open the chicken-loop and the FLYSURFER control bar
will slide to the kite on the safety line. The kite falls and blows
off safely with minimal residual pull on the safety line.
05.02 Assembly of a FLySURFER Quick Release
Keep the FLS Line pulled in during assembly to prevent the kite
from always flying and always keep an eye on your kite. Make
sure that no line wraps around your hand, other body parts, the
bar or the harness hook.
Hold the orange release handle up and make sure the re-
lease pin is in the open position. Place the end of the chicken
loop over the release pin while holding the release handle open.
Auslösen des Standard Safety Modus
Auslösen des Standard Safety Modus
Zusammenbau des QR
Zusammenbau des QR
Summary of Contents for CONNECT2
Page 1: ...USER MANUAL CONNECT2 EN...
