EN
GL
ISH
17
M
AI
NTE
N
AN
CE
Take the front lines in one hand and the steering lines in the
other hand and thread a pen (or screwdriver) through the end of
each line (pigtails).
Now tension the flying lines with approx. 10 kg. Hold the front
and steering lines side by side and compare the line lengths.
If you notice a difference, use the knot ladder to lengthen
or shorten the steering lines as described in the next point
„Lengthening or shortening the steering lines“. All flying lines
must be of the same length.
14.02 Extend a Steering Line
Push the floater along the steering leader line away from the
bar stick. Expose the knot ladder beneath the floater.
Open the lark‘s head knot.
Move the knot to the by one or two knots. Tighten the con-
nection.
Push the floater along the steering leader line until it sits
on the winder.
Repeat this process on the other side of the control bar.
Choose the same position on both sides and make sure the
knot of the steering leader line sits on top of it.
14.03 Exchange the Safety Line
Check the Safety Line for damage. If the white core of the line is
exposed, change the line immediately.
Take the Quick Release and pull the Safety Line with the
Safety Ring out.
Summary of Contents for CONNECT2
Page 1: ...USER MANUAL CONNECT2 EN...
