background image

FTr4

接收机  Receiver

http://www.flysky-cn.com

Copyright ©2021 Flysky Technology co., ltd

认证相关 

Certification

FCC Compliance Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause 

harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

 

Warning: changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to 

operate the equipment.

 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. 

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment 

generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause 

harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off 

and on, the user is encouraged to try to correct the interference by one or more of the following measures:

    Reorient or relocate the receiving antenna.

    Increase the separation between the equipment and receiver.

    Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

    Consult the dealer or an experienced radio/TV technician for help.

EU DoC Declaration

Hereby, [Flysky Technology co., ltd] declares that the Radio Equipment [

FTr4] is in compliance with RED 2014/53/EU.

The full text of the EU DoC is available at the following internet address: www.flysky-cn.com.

RF Exposure Compliance

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be 

installed and operated with minimum distance 20cm between the radiator and your body. This transmitter must not be co-located or 
operating in conjunction with any other antenna or transmitter.

Environmentally friendly disposal

Old electrical appliances must not be disposed of together with the residual waste, but have to be disposed of separately. The disposal at 

the communal collecting point via private persons is for free. The owner of old appliances is responsible to bring the appliances to these 

collecting points or to similar collection points. With this little personal effort, you contribute to recycle valuable raw materials and the 

treatment of toxic substances.

FCC ID :N4ZFGR4P00  

Summary of Contents for FTr4

Page 1: ...her information on how to connect and set up sensors 对码 Binding 1 将对码线插入 BIND 接口 2 将电源线插入其他任意接口 接收机指示灯快闪表示进入对码状态 3 将发射机进入对码状态 发射机进入对码状态的方式可能不同 请根据发射机的使用说明书进行操作 4 当接收机指示灯变为常亮时 对码成功 将对码线和电源线从接收机上取下 若发射机是单向 则当接收机指示灯慢闪时手动退出发射机 指示灯常亮 表示对码成功 对码成功后请将对码线取下 否则重新上电时将再次进入对码状态 在模型使用过程中若发生电源重启 这将导致模型失控 5 将电源线重新连接至接收机 接收机指示灯常亮表示对码成功 6 检查发射机 接收机 模型是否正常工作 如需重新对码 请重复以上步骤 1 InsertthebindcableintothereceiversBINDpor...

Page 2: ...do so may result in serious injury Make sure the receiver s battery is disconnected before turning off the transmitter failure to do so may lead to unintended operation or loss of control Make sure the receiver is mounted away from motors electronic speed controllers or any device that emits excessive electrical noise Keep the receiver s antenna at least 1cm away from conductive materials such as ...

Page 3: ...ning the equipment off andon theuserisencouragedtotrytocorrecttheinterferencebyoneormoreofthefollowingmeasures Reorientorrelocatethereceivingantenna Increasetheseparationbetweentheequipmentandreceiver Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiverisconnected Consultthedealeroranexperiencedradio TVtechnicianforhelp EUDoCDeclaration Hereby FlyskyTechnologyco ltd declare...

Reviews: