FS-G7P
Digital Proportional Radio Control System
Website
18
6.22 Receiver Settings - Bind Settings
The transmitter and the receiver have been bound with each other before delivery and can be
operated directly. If you want to replace the receiver, you need to bind the new receiver with the
transmitter by using the binding function before they can be operated normally.
Five parameters - RF system, RF type, receiving type, output mode, frequency - and a BIND key
are provided for setting purpose.
RF SYS
: To set between Fast and Routine. As for Routine mode, if the transmitter RF system is
set to Routine, it has strong anti-interference capacity for other models which are located in the
same enviroment and the closer distance. And for Fast mode, if the transmitter RF system is set to
Fast, then it has strong coexistence capacity among the samemodel tranmitters which are located
in the same enviroment and the closer distance, and it has lower latency.
RF type
: There are two options available, ANT1WAY one-way and ANT2WAY two-way. If you are
using a two-way receiver, it is recommended to select ANT2WAY two-way, which may bring you a
better experience with more information feedback.
ANT1WAY
means a one-way mode. In this mode, only the transmitter gives commands to the
receiver; while the receiver outputs and performs commands received from the transmitter. The
advantage is that it can ensure simultaneous operation by more users on the same site with less
interference.
ANT2WAY
means a two-way mode, which enables intercommunication between the transmitter
and the receiver to be configured with the corresponding functions, so that the basic information
of the model can be provided to the user in real time. For example, if you want to know the
battery voltage of the model vehicle, you can enable this option and bind the receiver configured
with this function, then you can read the battery voltage value on the transmitter.
Receiver type
: Two options are available, namely standard receiver and two-in-one receiver,
which can be selected according to the receiver you are using. The option of two-in-one receiver
means a receiver configured with a ESC; however, standard receivers are supplied by default. For
details, please visit our website to learn more about relevant models.
Output mode
: There are four optional output modes (combination of two output modes),
i.e., PWM/SBUS, PPM/IBUS, PWM/IBUS, PPM/SBUS four output modes, which can be selected
according to actual needs.
Servo frequency
: There are three optional output modes, i.e., analog, digital and others, which
can be selected according to the type of servo. The digit following each option is used to set the
frequency of the servo output.
Note
: The frequency of analog servos, digital servos and other servos are 60HZ, 380HZ and 50HZ-
400HZ respectively.
Function settings:
1.
In the BIND SET menu, select the item to be adjusted by pressing the UP/DOWN key and press
the OK key for editing. Set the desired value by pressing the UP/DOWN key and press the OK
key to confirm the adjustment.
2.
After the adjustment and setting are completed, select START by pressing the UP/DOWN key
and press the OK key to bind with the receiver. For details, please refer to the chapter for
Note
: When the transmitter is turned off for testing the Fail-safe function, please keep the model
elevated and fixed so as to avoid unexpected situations.
normally as expected.
